Put my X50 into Router mode and my Virgin hub is in modem only mode. Followed all the instructions. The Deco is only assigning IP addresses to wireless clients and none of my ethernet connected device

My setup WAS - router supplied by ISP - 6 x deco units My NEW setup is - Deco X50 is now the router, ie, it connects to fibre modem and feeds to other deco units - 5 x other deco units. It all works v

So just hooked up Archer GE800 today (replaced an Orbi setup hoping for some better QOS to help my son's gaming lag spikes, which I suspect are caused by our terrible 20Mb upload speed when things lik

On Firmware Version: 1.2.1 Build 20250610 rel.39070(5553) I notice if I click on Advanced/Traffic Monitor for the GE800, it instantly shoots me back to the Log In screen every single time no matter wh

To the tp-link router specialist, I've heard this before, but the EasyMesh on the Archer series routers from tp-link, which are heavily advertising Wi-Fi 7, is unable to mesh the essential MLO (Multi-

6GHz MLO not working with Ubuntu 22.04 WiFi7 Qualcomm Chipset, please find the Device Details below Network controller [0280]: Qualcomm Device [17cb:1107] (rev 01) Operating System: Ubuntu 22.04.1 LTS