Hi, I have a weird issue. I have just bought a SG105PE POE managed switch the idea being to use 3 ports for Poe devices (APs and a controller) and lag port 4 and 5 which is the non poe port. But port

After some advice / user experience, after buying Deco X10 units for my home to replace an EAP225 set-up, as the TP-Link site says they support vlans but neglects to mention that they don't in AP mode

Is there anything that I need to do to setup these adaptor to allow tagged vlan traffic. Yes there are post that says this should work, its a layer 2 device so should work but there is another post fr

How the guest wlan isolation has been implemented in AP mode in deco M9 latest firmware for v1 hardware? Does it have VLAN id and what is it? Why it cannot be set from user interface?