Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > i need a help for my router

< Wi-Fi Routers

i need a help for my router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

i need a help for my router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Davaanyam

2019-09-06 10:53:01

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-09-06

i need a help for my router

2019-09-06 10:53:01

Model: TL-WR940N

Hardware Version: V1

Firmware Version: i don't know

hello! yesterday night i unplugged my router from the internet cable and then i plugged it again but before that it was working properly but now it's not working can u help me to set up my network router. i checked the wire there's no damage at all. like when it's working properly it shows me blue light now it's sometimes blinking and showing me yellow light

2 Reply

ArcherC8

LV5

2019-09-06 12:05:16

Posts: 2110

Helpful: 842

Solutions: 49

Stories: 0

Registered: 2018-11-05

Re:i need a help for my router

2019-09-06 12:05:16

Power down the modem, router, and connected devices, wait a few minutes and then power up the modem, then the router, then the devices. Many times that will correct things. If not, connect a PC via ethernet direct to the modem bypassing the router and see if you have internet. If not then it is the modem or your ISP. Reconnect your router and if no internet through it, do a factory reset and reenter your settings and see if that works.

Kevin_Z

2019-09-09 08:48:41

Posts: 21609

Helpful: 5056

Solutions: 2546

Stories: 21

Registered: 2018-12-24

Re:i need a help for my router

2019-09-09 08:48:41

@Davaanyam

Orange means that the internet is not available.

Below are some suggestions:

1. Please login to the web UI of the TL-WR940N and verify the internet IP and gateway obtained by it.

2. Then please connect your computer to the modem directly and check whether you can access internet and please click here to get the IP and gateway.

3. You can power cycle them as the sequence: power off the router and modem both, then turn on the router first, once it booted up, turn on the modem.

4. Or you can connect the computer to the router and login to the web UI to clone the MAC address.

May it help and have a good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

i need a help for my router

i need a help for my router

Information

Voters 0

Tags