Add a calibration function to the t310 and t315 temperature and humidity sensors.
Add a calibration function to the t310 and t315 temperature and humidity sensors.
It would be useful if there was an ability to 'calibrate' these sensors so they read the same as other sensors and thermostats in the home. My t310 sensors all read slightly differently so being able to tweak up or down 0.1-0.5 of a degree would be useful
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
JohnS. wrote
We NEED calibration setting on these things. Please Tapo team!
I agree, placed two sensors, one new, inside a sealed container with a known humidity source, one sensor reads correctly, the older sensor by 6 months, is reading between 4% and 5% higher relative humidity.
There needs to be the ability to add an offset to account for the error.
- Copy Link
- Report Inappropriate Content
@I have a t315 sensor and I notice that the humidity measurement shows a difference of plus 7%. This means that my different humidity meters show 63% humidity and the t315 shows 70% humidity. All three sensors that I used for comparison are from different series and are not Smart. Two of the sensors cost €20 each and one was a little cheaper at €10. So from that point of view it would be good to implement a calibration function for the t310 and t315 series.
- Copy Link
- Report Inappropriate Content
Agree, urgently needed.
I got a number of ThermoPro non-smart Sensors around the house and they agree on Temperature and Humidity in any given location ... with the T315s constantly showing 5-10% higher humidity in the same spot.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@SchlitzAfter removing the battery compartment cover of the t-315, the accuracy of the humidity
the different now is ca. 4-5% Plus
Bevor removing the different is 6-8% Plus
- Copy Link
- Report Inappropriate Content
Information
Helpful: 10
Views: 1685
Replies: 15
Voters 10
