Does ER8411 support subinterface?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Does ER8411 support subinterface?
Does the ER8411 support subinterface? My L3 switch doesn't support dhcp server only relay, the L2 switch I have in the network does support dhcp server but when there is a load it just locks up the daemon.
I was wondering if the ER8411 can become the dhcp server, but it would have to make the SFP+ WAN/LAN port a subinterface to pass L2 requests.
Remember in my topology my L3 is routing to the ER8411.
Layer 3 Config #conf t
(config)# interface te 1/0/1
(config-if)# no switchport
(config-if)# ip address 192.168.1.2 255.255.255.252
(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.1
1 Accepted Solution
