Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Replacing main deco xe75pro with a TP-Link BE9300

< Deco

Replacing main deco xe75pro with a TP-Link BE9300

Kamark

2024-10-25 13:55:28 - last edited 2 weeks ago

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-10-25

Replacing main deco xe75pro with a TP-Link BE9300

2024-10-25 13:55:28 - last edited 2 weeks ago

Tags: #Presales

Model: Deco XE75 Pro

Hardware Version:

Firmware Version: 1.2.11

I have 4 xe75pro deco unit. I looking to replace main deco (acting as router) with a tp link router be9300 then replaced deco will be used as another mesh unit within same network. Is it possible to set up? Or do i need to keep the main deco connected with the new router? As i understand i can not use deco app for the router i need to use tether app. Please explain the procedure. Thank you.

1 Accepted Solution

David-TP

2024-10-28 09:08:06 - last edited 2 weeks ago

Posts: 12575

Helpful: 1748

Solutions: 1211

Stories: 9

Registered: 2020-04-14

Re:Replacing main deco xe75pro with a TP-Link BE9300-Solution

2024-10-28 09:08:06 - last edited 2 weeks ago

@Kamark

Hi, the first Deco XE75 Pro needs to connect to BE9300(is it Archer BE550?) via an Ethernet cable.

To avoid double NAT, it is suggested to set Deco into access point mode:How to set up Deco to work in Access Point mode

(If you don't want them broadcast separate SSIDs, please try to disable the Wi-Fi on the BE9300).

Furthermore, If you just purchase TP-Link BE9300, I think Deco BE65/BE65 Pro would be better to work as the main router since they both belong to the Deco family and could establish a Mesh system together.

Thank you very much and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶Deco X50-5G-V1-1.2.0 Supports WireGuard VPN, Hybrid Mesh and More Try to leave a Message if urgent help is required.

Recommended Solution

1 Reply

David-TP

2024-10-28 09:08:06 - last edited 2 weeks ago

Posts: 12575

Helpful: 1748

Solutions: 1211

Stories: 9

Registered: 2020-04-14

Re:Replacing main deco xe75pro with a TP-Link BE9300-Solution

2024-10-28 09:08:06 - last edited 2 weeks ago

@Kamark

Hi, the first Deco XE75 Pro needs to connect to BE9300(is it Archer BE550?) via an Ethernet cable.

To avoid double NAT, it is suggested to set Deco into access point mode:How to set up Deco to work in Access Point mode

(If you don't want them broadcast separate SSIDs, please try to disable the Wi-Fi on the BE9300).

Thank you very much and best regards.

Replacing main deco xe75pro with a TP-Link BE9300

Replacing main deco xe75pro with a TP-Link BE9300

Information

Voters 0

Tags