C64 Led control doesnt work properly- it turns on after reboot
C64 Led control doesnt work properly- it turns on after reboot
Hi, I have two C64s and led turns On after reboot both on satellite and main router.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello@YuriyB ,
Welcome to our community.
Have you created an EasyMesh network between Archer C64 routers?
Currently, the satellite router cannot synchronize most functions with the main router, such as guest networking and LED control.
For the main router, even if you disable the LED status, will the LED status still be enabled after restarting the main router?
- Copy Link
- Report Inappropriate Content
@Joseph-TP HI,
yes, my routers in in EasyMesh and led control dont work for both router and AP modes
Joseph-TP wrote
For the main router, even if you disable the LED status, will the LED status still be enabled after restarting the main router?
YES
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
Do you remember how you obtained that particular beta firmware version 1.14.3 Build 240925 back then?
I am only aware of the "official" firmware version 1.14.3 Build 241025 (i.e. 2024-Oct-25) that can be downloaded from the Archer C64 product website and the beta firmware version 1.14.3 Build 241128 that was posted in this forum to address an issue present in the official version 1.14.3 Build 241025. https://community.tp-link.com/en/home/forum/topic/735384
Unfortunately, I don't have my own Archer C64 at hand currently and therefore can't test for you if the LED Status is working with these newer firmware builds.
- Copy Link
- Report Inappropriate Content
Hi@YuriyB ,
Thanks for getting back to me.
Please turn off the satellite unit and disable the LED status. Then reboot the main router again. Please check if the LED turns back on.
If yes, please send backup file to support.forum@tp-link.com, attaching [Forum ID 836174] and details, and we will have a dedicated person to assist in analysis and follow-up.
Please refer to the FAQ below to collect backup files of the router: How to create and restore from a backup file on your TP-Link Router
- Copy Link
- Report Inappropriate Content
@Joseph-TP Thanks for reply,
Just did all steps and LED turns On after reboot.
Led Status turns ON in standalone mode.
I dont want to send my configs to tplink
- Copy Link
- Report Inappropriate Content
Hello@YuriyB,
May I know why you don't want to provide your configuration information? Do you have any concerns?
Our engineers can use this information to reproduce the issue, which helps them better identify the problem.
Please don't worry about security issues; our engineers are professional and will only collect your information with your consent.
Of course, we fully respect your decision not to provide your configuration information.
- Copy Link
- Report Inappropriate Content
@Joseph-TP Hi, thanks for reply
I'm worried that your professionals since 2021 (release date of C64) couldn't make a stable firmware with port-forwarding\opening problems while in mesh, freezes with ACL enabled, buggy smartconnect and disabling LED function.
- Copy Link
- Report Inappropriate Content
Hi@YuriyB ,
I understand your concerns.
However, escalation to an engineer is a one-on-one communication. I currently don't have any other suitable suggestions for you.
I trust the professionalism of our engineers to accurately identify the issue and provide an appropriate solution.
- Copy Link
- Report Inappropriate Content
For everyone who want to turn off led, here's solution:
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 311
Replies: 11
Voters 0
No one has voted for it yet.