Deco M4_V1/V2_1.8.0 User Feedback
Deco M4_V1/V2_1.8.0 User Feedback
This Article applies to
Deco M4_V1/V2
Firmware Modifications:
- Enhanced System Security
- Improved Client management experience on the Deco APP.
- Fixed the issue that the IPv6 communication between client devices might fail when the assigned type was set to DHCPv6.
- Fixed the issue that the real-time speed rate was "--/--" in the Deco APP.
Note: This version upgrade is irreversible, and you cannot downgrade to the previous firmware after the upgrade.
Firmware Version:
| Deco M4_V1/V2 | 1.8.0 Build 20250721 Rel. 49216 |
As the previous post about version 1.7.0 was too long to navigate for information on the newly released 1.8.0 version, I have created this new post. Kindly share your feedback on how the new 1.8.0 works. Your input will greatly benefit other users.
Thank you very much.
▶Check What's Currently Going on With Deco
▶Parental Control Upgrade on HomeCare Models
▶Deco BE85 1.2.0 Enhanced Mesh Backhaul Stability and Device Roaming Experience
▶Deco BE65/BE65 Pro 1.2.0 Enhanced Mesh Network Stability and System Security
▶Deco BE75 1.1.0 Added WireGuard VPN, Manual Channel Selection and More
Try to leave a Message if urgent help is required.
Re:Deco M4_V1/V2_1.8.0 User Feedback
@David-TP we need auto channel width at Deco X and BE series.
Sayeem Ahmed
from Bangladesh
Re:Deco M4_V1/V2_1.8.0 User Feedback
@David-TP We need 
Deco X50v1.30 to support Channel Width 20/40/80/160/320 in Auto mode, like Archer AX53 or AX73.
Sayeem Ahmed
from Bangladesh
