ER605 shows local link IPv6 on WAN status

ER605 shows local link IPv6 on WAN status

ER605 shows local link IPv6 on WAN status
ER605 shows local link IPv6 on WAN status
a week ago - last edited Yesterday
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.3.0

Hi.

I configured the WAN settings for a new ISP. Due to CGNAT, I had to activate IPv6.

 

 

The connection was established successfully.
However, the router status now shows a local link address for IPv6. Is this correct or maybe a bug?

 

I did receive a valid IPv6 address from my provider, which I can also see in the prefix delegation settings in the LAN configuration.

 

Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:ER605 shows local link IPv6 on WAN status-Solution
Yesterday - last edited Yesterday

  @Chr1schan 

Please check whether the WAN port has obtained an IPv4 address, and also verify on the client side that the WAN IP is an IPv4 address. The behavior suggests that your WAN port is likely receiving an IPv6 address instead.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:ER605 shows local link IPv6 on WAN status-Solution
Yesterday - last edited Yesterday

  @Chr1schan 

Please check whether the WAN port has obtained an IPv4 address, and also verify on the client side that the WAN IP is an IPv4 address. The behavior suggests that your WAN port is likely receiving an IPv6 address instead.

Recommended Solution
  0  
  0  
#2
Options