Solution Fixes: Smart Control Not Working on Kasa KE110 and Linked KE100
This Article Applies To
- KE110(EU) V1.0 - Firmware 1.1.0 Build 250225 Rel.192437
- The KE100 that is linked with the KE110
Description
When linking a KE100 to a KE110, you may find that the Smart Control settings on the KE100 do not work as intended. For instance, the target temperature may not adjust according to the schedule, and heating may continue based on the previous plan even after a new schedule is set to begin.
Workaround
R&D has developed new firmware that addresses this issue. Before the official release, community users are provided early access to the firmware. If you would like to have a try, follow the instructions below to apply the firmware.
How to Apply Beta Firmware
1. Find the Mac address of the KE110 and the connected KH100 hub: Open the Kasa app and navigate to the smart device's Device Settings page > Device Info.
2. Send a private message to @Wayne-TP with this format:
[KE110 Smart Control Issue] + Mac address of your KE110 and the KH100
Before the Upgrade
(1) Please be sure you have read the Beta Test Agreement before upgrading the Pre-release firmware!
(2) How to update firmware of Kasa smart devices
(3) Firmware downgrade is not supported. When a new official version is released, updating it will overwrite the beta version.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Wayne-TP Same here. I sent you massage, please help ;)
- Copy Link
- Report Inappropriate Content
@Pablo87 @Stuart-TP Beta firmware has been sent to your devices, you may check it 30 minutes later in the Kasa app and perform the update.
- Copy Link
- Report Inappropriate Content
@Wayne-TP Thanks a lot :)
- Copy Link
- Report Inappropriate Content
@Bichel619 @Fauphi @Izzoe Beta firmware has been sent to your devices, you may check it 30 minutes later in the Kasa app and perform the update.
- Copy Link
- Report Inappropriate Content
After two weeks of testing with new beta firmware everything works as it should now.
Thank you!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Wayne-TP I observe a similar issue of a zig zag heating pattern with a linked T315. I also observe this zig zag pattern with actually no linked external temperature sensor. Overall it looks more like those thermostats are controlled with a bang-bang controller instead of a nice pid controller.
Are there beta firmares available for KE100 ( and T315) for testing?
- Copy Link
- Report Inappropriate Content
@yonajon @EN8 @Christian198215 @Michael_Herz @Ariadne2
Beta firmware has been sent to your devices, you may check it 30 minutes later in the Kasa app and perform the update.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 5710
Replies: 31
Voters 0
No one has voted for it yet.