After update the last firmware version 1.8.0 Build 25102213 Rel. 43970 i notice that one of my decos in my network seems to lose its settings.

i try to reset hard and soft but no change.

the problems that i notice are:

1. the devices of my network cannot connect with wifi at this deco but in the other devices connected normally.

2. if i select this deco to "send" internet to other deco the other deco disconnect from the network.

3. but if i set the deco as receiver from other deco it work only with wire connection and during the day restarts 2-3 times.

4. i cannot connect from browser with deco ip because it does not recognise the credentials (the other deco connected normally).

5. sometimes i see in available wifi the default deco name as a seperate network but it doesnot connected to the internet.

finally this deco is part from 3 pack deco system.