I am trying to use a T315 and a P110 to control a heating system.

The idea is when the temperature reported by the T315 is under 19º the P110 should be turned On.

And when the temperature goes over 20º the P110 should be turned on.

The idea is simple.

I have made all the smart actions needed and a button to enable the smart actions (automatism).

When I run the button that enables the automatism (being 17º in the T315 and staying Off the P110), the P110 remain turned off.

But the rule says "If T315 is under 18º the P110 should be turned ON".

The real thing is that only works the rule if the temperature cross the 18º level.

So if the temperature of the room is 19º and drops to 18º and then drops to 17º, the rule is applyed and the P100 is turned on.

But if the initial temperature is under the limit of 18º, the rule never applies.

The real meaning of the condition is not "if the temperature in under 18º", the real thing is "If the temperature drops from 18º to 17º..."

This makes very poor useful the smart actions.

Somebody does it know how launch a P110 turns ON when the temperature is under 18º (not when the temperature drops from 18º to 17º)?

Is totally diferent that launch a P110 when the temperature is in one state (under 18º)

that when the temperature drops from 18º to 17º, wich make in fact unuseful the smart actions.

Could somebody give to some help, idea or I have to ask for a new feature?

Manuel (Domoter)