NC200 camera - "connection error" in TPLINK camera control
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC200 camera - "connection error" in TPLINK camera control
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
I I've got 4 NC200 cloud cameras. The 2 of them are wired connected and the other 2 are wireless connected. I use the TPLINK Camera Control for windows and the wired connected cameras are working good enough with some "connection errors" but after some seconds are reconnected. The problem is with the wireless connected cameras. If the the message "connection error" appears they dont reconnect until I unplug and replug the power. I had the same problem before firmware update and after the latest firmware update
Any suggestions?
Hardware Version :
Firmware Version :
ISP :
Hi,
I I've got 4 NC200 cloud cameras. The 2 of them are wired connected and the other 2 are wireless connected. I use the TPLINK Camera Control for windows and the wired connected cameras are working good enough with some "connection errors" but after some seconds are reconnected. The problem is with the wireless connected cameras. If the the message "connection error" appears they dont reconnect until I unplug and replug the power. I had the same problem before firmware update and after the latest firmware update
Any suggestions?
