TP-Link Camera Control (for Windows) Feature Request
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link Camera Control (for Windows) Feature Request
Model :
Hardware Version :
Firmware Version :
ISP :
Hi, I am recently using a TP-Link NC450. I would like to perform security recording in a centralized manner. It seems like the Camera Control program for Windows is the only method to do so. However, the program is overly simple and lacking many important features. Two of the features I would like to request for are critical to manage disk space consumption (of recorded videos) and to ease searching for an event:
1) Set disk usage quota - I don't want the program to use my entire 2TB drive to do recording, and uncertain what would happen once the space runs out. It would be nice if I can limit the recording space used to 500-1000GB, knowing the oldest recording will be deleted to make way for new recording.
2) Record based on motion detection - I don't want the program to be recording nothing happening 24/7 and filling up my limited disk space. It would be good if the program can record only when events are detected. It would also ease searching for an event when reviewing the records.
There are more feature suggestions, but I think those can come later. These 2 are the most critical to making the NC450 much more usable as a security surveillance camera. Otherwise, it's just a toy camera for me to view from mobile phone, and limited SD card space to capture short sequence of events.
Thank you very much.
Hardware Version :
Firmware Version :
ISP :
Hi, I am recently using a TP-Link NC450. I would like to perform security recording in a centralized manner. It seems like the Camera Control program for Windows is the only method to do so. However, the program is overly simple and lacking many important features. Two of the features I would like to request for are critical to manage disk space consumption (of recorded videos) and to ease searching for an event:
1) Set disk usage quota - I don't want the program to use my entire 2TB drive to do recording, and uncertain what would happen once the space runs out. It would be nice if I can limit the recording space used to 500-1000GB, knowing the oldest recording will be deleted to make way for new recording.
2) Record based on motion detection - I don't want the program to be recording nothing happening 24/7 and filling up my limited disk space. It would be good if the program can record only when events are detected. It would also ease searching for an event when reviewing the records.
There are more feature suggestions, but I think those can come later. These 2 are the most critical to making the NC450 much more usable as a security surveillance camera. Otherwise, it's just a toy camera for me to view from mobile phone, and limited SD card space to capture short sequence of events.
Thank you very much.
