Smart Home Community > All Threads > NC450 initial position
< All Threads

NC450 initial position

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

NC450 initial position

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC450 initial position
NC450 initial position
2017-08-22 18:38:54
Model : NC450

Hardware Version : NC450 2.0

Firmware Version : 1.2.4 Build 170322 Rel.85B2CB

ISP :

Hi

Is it possible to change the "initial position" button when using turn/tilt to stop on an nother position than the standart.
  0      
 
  0      
 
#1
Options
4 Reply
Re:NC450 initial position
2017-08-23 09:05:08
you mean the reset button in the center? I don't see there is a way to change its position
  0  
  0  
#2
Options
Re:NC450 initial position
2017-08-23 13:55:55
Yes the reset button.
  0  
  0  
#3
Options
Re:NC450 initial position
2017-08-23 14:31:18


  0  
  0  
#4
Options
Re:NC450 initial position
2017-08-23 16:45:09
I don't see a way to change it
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 852

Replies: 4

Related Articles
NC450 Preset Position
663 0
NC450 - camera position is reset
1594 2
How to set a Preset (Home) position on NC450 camera?
926 0
NC450 Preset Positions
765 0
NC450 Not powering up
764 0
NC450 not connect
5863 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.