@TaylorFusion Hey The channels on 5ghz that are DFS (basically anything not 36-48) should be fine to run both your APs on, as the airspace will be clean and only your APs there.. its perfect :) Each...

@yianny Hey No there is no settings required, simply connect the Main Sky Q box via wireless as you would normally. Then reset the Mini Boxes and during network setup, just plug them into the Deco...

@TaylorFusion THis concerns me a tad, its reading -65db from AP which is .. OK.. ideally you would want this sub 60 if honest as when you start hitting ~75 its end of usable signal. This would also...

@TaylorFusion Basically the more YELLOW the better, AMBER is more interference and RED avoid. As you are using 89mhz channels, both 42 and 155 are very quiet. As you selected 149 as you channel you...

@MiguelS To my knowledge the EAP610 is brand spanky new, in that it's still only got the original release firmware. If the other EAPs are anything to go by, the channels and tonnes of fixes will come...

@TaylorFusion Hey On the controller select DEVICES on the left Then select your Access Point... On the right pop in menu under CONFIG RADIOS you should be able to force an 80 wide channel width for...