Hi @BobDownSouth Thanks for posting here. Since you already have a switch and the APs are connected via wired links, the mesh function is not required. Mesh is typically used when cabling is...

Hi @dinosaurscuba Thanks for posting here. The above is an explanation of the “disconnected” status. Since the device’s network was not affected during the disconnect, the issue likely lies in...

@chrisdfw @angrynerd @chrisdfw The 28 dBm you set is the EIRP (Equivalent Isotropically Radiated Power), which is the final transmit power limited by regulations. The 22 dBm displayed on this page is...

Hi @arrmo Could you please let us know what type of controller you are using? We recommend submitting a support ticket via email for efficient assistance. Please include the following information in...

Hi @lukepo Generally, this is unlikely to be the cause. Signal strength only affects stability and performance. lukepo wrote Is it possible if signal from uplink device is weak lets say -66dBm than...

Hi @lukepo Thanks for the reply. Currently, it appears that your VLAN configuration does not align with common scenarios. When “None” is selected, different VLANs are isolated by default, which may...