Forums/
WiFi
2020-09-12 18:21:00
@Leon71, first, an EAP115 has only a Fast Ethernet (100 Mbps) interface, so max. throughput can't raise over 100 Mbps full-duplex . Secondly, the 300 Mbps is the maximum WiFi rate of an EAP115 over a...
0HELPFULS
Forums/
Controllers
2020-09-12 17:06:21
Bobby1859 wrote it's 802.3af power, 56 Watts total, and 15.4W per port across I think four ports, the total not to exceed the 56W max. We have just one PoE device on this switch, the EAP245 which...
0HELPFULS
Forums/
WiFi
2020-09-11 23:13:02
@wz1, Tach! Ein EAP110 kann nicht via PoE 802.3af/at (48 Volt) versorgt werden, das Gerät nutzt ausschließlich passives PoE (24 Volt).
0HELPFULS
Forums/
WiFi
2020-09-11 22:51:26
ReneT wrote GS108 VLAN100 = Port 1...4 (Port 1..3 Untagged, Port4 Tagged) GS108 VLAN1 = Port 4...8 (Port 5...8 Untagged, Port4 Tagged) Hier liegt der Fehler. Wenn Du VLAN 1 untagged im CAP300...
0HELPFULS
Forums/
WiFi
2020-09-11 22:37:43
@Nardino, select »Hotspot« as authentication type, then enable »Voucher« as hotspot type:
0HELPFULS
Forums/
WiFi
2020-09-11 22:29:25
nirvanaman wrote the irl tplinkeap.net not ok You can connect to an EAP using its IP address. But if managing an EAP with Omada Controller, you should not need to connect to an EAP directly. Set the...
0HELPFULS