Boriy wrote I was referring to a place where all switches located. I did understand this perfectly. You asked whether it's true that »this should make troubleshooting more easier for IT department«....

@Bobby1859, yes, you will see a disconnect state after few minutes. Does your PoE switch provide an af or an at power budget?

@the-Barry, try to reset the EAP to factory defaults. Press the RESET button on the EAP225-Outdoor (not on the PoE adapter, this is a dead button) for 7-8 seconds until the LED flashes and indicates...

@Cnote, what PoE switch do you use? 802.3af or 802.3at? If the former, try the PoE injector directly at the EAP in the 1st floor to verify that the cable is good. If the latter works, the loss of...

Bobby1859 wrote But even if we did, why would an EAP, directly set to static AP, at least through Omada, change it's IP and mask? Yes, Omada controller sets the IP in the EAP directly; it's stored in...

@JSchnee21, if you have two 2x2 MIMO clients the EAP245 will use 2 spatial streams for device #1 and two spatial streams for device #2 (that's the »MU« in »MU-MIMO«, which stands for »Multi-User«)....