Dear @luxor84, luxor84 wrote What I find a little bit strange is the source port from the ER605... Is it normal that it changes like that for the NTP protocol? I think it's normal as the source port...

Dear @yorkman, yorkman wrote Thanks for the response. Just the one EAP device. And it wasn't an Adopting -> Provisioning loop. It was simply stuck at Adopting. The status would never change to...

Dear @yorkman, yorkman wrote Last night I got the AP adopted for the very first time. The Omada controller software v5.0.29 showed connected and everything was fine. Today, I connected to work via my...

Dear @mackworth, mackworth wrote I observed that I do in fact see ".... ..1. = Neighbor Report: Enabled" under "Tag: RM Enabled Capabilities (5 octets)" which implies that it is enabled, however I...

Dear @BerryBoy, BerryBoy wrote @Philbert When I tried from my browser on my desktop PC, I was connecting directly to the IP of my controller. The login page comes up, but it just fails with "Request...

Dear @shivamg42, shivamg42 wrote @Fae Thank you. Ended up getting it wokring a few minutes ago! Glad to hear that your concern was resolved finally. I noticed that you have reported a problem in this...