Dear @waldi.top, waldi.top wrote If I want to connect oc200 with my existing source of internet that has an ip 192.168.0.x/24. Then my other router connect to this router, what ip segment should I...

Dear @CoKro, CoKro wrote System Time is accurate (minus the daylight savings issue that I can deal with) but the corresponding time in the logs is just wrong. Current error (a few minutes ago) shows...

Dear @waldi.top, After the firmware recovery, what are the LED indicators on your OC200? Are the LEDs for ethernet ports still blinking even if there is no cable plugged into your OC200? Are you...

Dear @donmartino77, donmartino77 wrote I noticed that the Omanda SDN does not always display correct results. Example: I have a client01 which is directly connected to the switch port 10. The switch...

Dear @Dillius, Dillius wrote @Fae I think the confusion is that I did not know about this device password settings before I went ahead and reset the devices. Even if it WAS in the backup, the...

Dear @Larz256, Larz256 wrote @Fae That bring up an interesting point; Once registered, does the controller reach out to devices (push) or do the devices poll into the controller (pull) for...