Greetings gentlemen have a question at the moment I have 3 wired points connected bought another one and added it as a mesh connection but already for 4 weeks I have not seen a single client conne

Where is the network configuration stored? On the controller? or on the hardware. Here is my scenario. Yes, I know about backups. this has not actually happened. I just want to understand how this wor

When I was configuring the radios of EAPs, I found out I could not modify the Wi-Fi modes of each. I want to use only 11g/n modes because I don't have devices that use 11b.

So I bought an EAP110 Outdoor antenna. I was able to establish connection with Omada Software Controller version 4.2.8 and completed all the necessary settings like voucher and stuff.. but at the end

Hi Guys! Iam using a Oc200 together with 6 EAP615 Wall AP. For 1 AP i would need Mesh (,Wireless Backhaul) Is there a plan in the future to get this function via FW Update?? Thx Christian

I have following setup 1. LOAD BALANCE ROUTER TL-ER5120 2. POE SWITCHT TL-SG1210P 3. EAP225 (8no) I want to create mesh. Can i do it with software controller or i need OC200 hardware? If software cont