NC260 fail to connect after firmware upgrade

NC260 fail to connect after firmware upgrade
NC260 fail to connect after firmware upgrade
2019-09-26 06:59:02 - last edited 2019-11-02 13:14:01
Model: NC260
Hardware Version: V2
Firmware Version: unknown

Hi, My camera totally cannot use after firmware upgrade.

Right now im not sure what is firmware version since i cannot view camera information from my TPlink sw.

I try remove the camera from sw and setup again the camera, but now, im facing "camera cannot be found" when try to search the camera after LED light permanent stay.(mean wifi is connected)

Any one has same experience before. Need help..

 

0
0
#1
Options
1 Accepted Solution
Re:NC260 fail to connect after firmware upgrade-Solution
2019-11-02 13:13:49 - last edited 2019-11-02 13:14:01

@netliner yes im pretty sure its firmware problem. After reinstall the firmware, my camera back to normal condition. Issue solved

Best Solution
0
0
#3
Options
2 Replies
Re:NC260 fail to connect after firmware upgrade
2019-10-02 10:27:05

@Ferdaus  I had the same issue getting the camera to connect via wifi. If it's through cable, no issue. I think is the firmware problem.

0
0
#2
Options
Re:NC260 fail to connect after firmware upgrade-Solution
2019-11-02 13:13:49 - last edited 2019-11-02 13:14:01

@netliner yes im pretty sure its firmware problem. After reinstall the firmware, my camera back to normal condition. Issue solved

Best Solution
0
0
#3
Options