TP-Link Community > Kasa Cameras > Cannot install KC100
< Kasa Cameras

Cannot install KC100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cannot install KC100

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot install KC100
Cannot install KC100
2019-12-04 00:25:15
Model: KC100  
Hardware Version:
Firmware Version:

When I plug in the camera, I get a red flashing light.  It may briefly turn green, but it always goes back to red.  The camera worked previously, and I've tried it close to and far away from my router.

  0      
 
  0      
 
#1
Options
1 Reply
Re:Cannot install KC100
2019-12-04 22:14:50

@Jet 

 

The blinking red is the camera failing to connect back to the Wi-Fi.

 

What would be recommended is to do a complete factory reset by holding the reset for 20 seconds. Then installing the camera back into  the Kasa app. If the Kasa cam still exists in the app, remove it, then add it again.

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 521

Replies: 1

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.