Home Network Community > Range Extenders > How set RE450 System Time
< Range Extenders

How set RE450 System Time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How set RE450 System Time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How set RE450 System Time
How set RE450 System Time
2020-02-14 22:03:42
Model: RE450  
Hardware Version: V2
Firmware Version: 1.0.4

How do you set the system time on a RE450?  The instructions only tell how to set time zone and daylight savings time.

  0      
 
  0      
 
#1
Options
4 Reply
Re:How set RE450 System Time
2020-02-19 23:23:27

@HH70 

 

There is no way to directly adjust it, the time will be what the time zone is set to. If it is incorrect, reboot the RE450 or unplug it and plug it back in. What should happen is once the RE450 gets connected to the internet the correct time will then be adjusted to the extender.

  0  
  0  
#2
Options
Re:How set RE450 System Time
2020-02-20 21:39:47
Rebooting or power cycling does not work. I just wanted to schedule the power off at night. The repeater works fine otherwise.
  0  
  0  
#3
Options
Re:How set RE450 System Time
2020-02-24 23:22:59 - last edited 2020-02-24 23:23:38

@HH70 

 

How far off is the time showing from what it should be?

 

What time zone are you in, and what do you have set in the extender for the daylight savings?

  0  
  0  
#4
Options
Re:How set RE450 System Time
2020-02-25 00:05:31
The time is off by 3 years, 50 days, 15 hours and 12 minutes. It is show a time of 1/5/2017, 3:48. It was 7 PM when I looked. I do not have daylight saving time set.
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 850

Replies: 4

About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.