Home Network Community > Range Extenders > RE220 Ethernet not working even though it did previously
< Range Extenders

RE220 Ethernet not working even though it did previously

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE220 Ethernet not working even though it did previously

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE220 Ethernet not working even though it did previously
RE220 Ethernet not working even though it did previously
2020-04-27 01:59:47
Model: RE220  
Hardware Version:
Firmware Version:

I have a RE220 which I plugged my ethernet cable in to see if the speeds would be faster since I was using it as a range extender which is what I want to use it for and it worked great for a day or so with much higher speeds than wireless connection to my extender and router but then stopped working and said no internet. I reset multiple times and updated firmware nothing will work. How Can I fix this?

 

  0      
 
  0      
 
#1
Options
5 Reply
Re:RE220 Ethernet not working even though it did previously
2020-04-28 16:08:38

@lucasShaw 

 

If you are going to connect an Ethernet cable to the extender from the router the extender needs to be configured as an Access Pont.

 

Here is how you would set that up: https://www.tp-link.com/us/support/faq/1401/

  0  
  0  
#2
Options
Re:RE220 Ethernet not working even though it did previously
2020-04-28 18:02:30

@Tony  No that was not the purpose I was using the ethernet cord for it was to connect the ethernet cord from my extender to my PC for better speeds. But it stopped working. How do I fix that?

  2  
  2  
#3
Options
Re:RE220 Ethernet not working even though it did previously
2020-04-28 23:50:14

@lucasShaw 

 

The extender might no longer be connected to the router. Log into your router and look at the connected devices to see if the RE220 is seen. If not try unplugging it and plugging it back in. If the RE220 still is not connected try factory defaulting it by holding the reset for 15 seconds while it is plugged in, then set it up again: https://www.tp-link.com/us/support/faq/1373/

  0  
  0  
#4
Options
Re:RE220 Ethernet not working even though it did previously
2022-02-28 15:27:41

  @lucasShaw have you found a fix for it? i just purchased one and it is doing the exact same thing.

  0  
  0  
#5
Options
Re:RE220 Ethernet not working even though it did previously
2022-02-28 15:29:03
I am having the same problem but my extender is showing up and connected to my router. Any fix for this?
  3  
  3  
#6
Options

Information

Helpful: 0

Views: 8429

Replies: 5

Related Articles
 RE220 OneMesh not working in AP mode
1387 0
Can I create a OneMesh network using two RE220 using their ethernet to connect to my modem?
1339 1
 RE220 Extender Mode, Dead Ethernet Port
537 0
 RE220
819 0
 RE220 - both units stopped working. Only solid light.
1000 0
5GHz Guest network available even though not enabled
499 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.