Home Network Community > Range Extenders > RAbge extender connect to router but no internet access
< Range Extenders

RAbge extender connect to router but no internet access

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RAbge extender connect to router but no internet access
RAbge extender connect to router but no internet access
2020-09-23 13:36:27

Hi I have connected my new AC750 range extender for both 2.5 and 5 GHz to my router but it will not connect to the internet.  What should I do?

0
0
#1
Options
1 Reply
Re:RAbge extender connect to router but no internet access
2020-09-23 20:10:01

@DCy 

 

Check the router settings to make sure the extender internet access is not being blocked.

 

You could also try statically assigning the extender an IP address that is outside of the DHCP pool of the router.

 

If the 2.4G and 5G are named the same, make the 5G different on the router, then set up the extender again.

 

Visit our official website and look at the firmware section of your extender. Use the build date to verify the firmware is up to date.

0
0
#2
Options
Related Articles
Range extender connected but no internet access
9617 0
TP-Link Mesh Wifi Extender AC750 Dual band (RE200) - Connected to Router but "no internet access"
881 0
Range Extender connected to router but no longer putting out internet signal
10677 0
Connected to new new ARRIS router, but no internet signal
762 0
RE220 connected but no internet access
909 0
RE450 connects but no Internet
8448 0
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.