Home Network Community > Range Extenders > Changing Channel
< Range Extenders

Changing Channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Changing Channel

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Changing Channel
Changing Channel
2021-02-02 04:41:21
Model: RE450  
Hardware Version:
Firmware Version:

I want to change the channel on my RE450 that's connected to my TL-WDR3600 router. 

 

If I change the channel on the router then reset the RE450 (paper clip hole) will it automatically find and reconnect to the router and be on the new channel?

 

Or must I also login to the RE450 and change it there? I've lost my username and password, so that will require a factory reset of the RE450 if so.

  0      
 
  0      
 
#1
Options
1 Reply
Re:Changing Channel
2021-02-02 19:20:14

@DFW_Mark 

 

After changing the channel on the router, you would then reboot the extender which should then change to the channel the router is at. If not, reset the extender (hold reset for 15 seconds), then set it up again, which it will then have the new channel after setup.

  1  
  1  
#2
Options

Information

Helpful: 0

Views: 435

Replies: 1

Related Articles
Changing channels
342 0
Changing channels
414 0
Changing network channel
324 0
AX80 changing channels
70 0
Deco X68 - Changing channels ability
370 0
Deco X68 - Changing channels ability
1633 1
About Us
Press
Copyright © TP-Link USA Corporation. All rights reserved.