Another Pairing Question TL-WPA8630 KIT V2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Another Pairing Question TL-WPA8630 KIT V2
Model :
Hardware Version :
Firmware Version :
ISP :
I just paired my TL-WPA8630 KIT V2. It went like clockwork. Classic, according to the book. However, when I place the receiver in the location where I want it to ultimately be (another building about 100 ft away) I lose the powerline paired light. Now I still get internet connection. Both the 2.4ghz and 5.0 ghz work fine. I just lose the powerline light. Now my understanding is that when the two units are paired (which they were) the light will light. When they are on the wrong circuit it will go to red. and when not paired the powerline light will not be lit. I hate to fool with it too much as it appears to be working right now. Should I try to re-pair the base and receiver again in their final locations?
Hardware Version :
Firmware Version :
ISP :
I just paired my TL-WPA8630 KIT V2. It went like clockwork. Classic, according to the book. However, when I place the receiver in the location where I want it to ultimately be (another building about 100 ft away) I lose the powerline paired light. Now I still get internet connection. Both the 2.4ghz and 5.0 ghz work fine. I just lose the powerline light. Now my understanding is that when the two units are paired (which they were) the light will light. When they are on the wrong circuit it will go to red. and when not paired the powerline light will not be lit. I hate to fool with it too much as it appears to be working right now. Should I try to re-pair the base and receiver again in their final locations?
