Home Network Community > All Threads > Network expansion not working
< All Threads

Network expansion not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Network expansion not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Network expansion not working
Network expansion not working
2019-07-31 21:04:43
Model: TL-WPA7510 KIT  
Hardware Version: V2
Firmware Version:

Have set up my TL-WPA 7510 kit with one extender and all is well..  All lights green.  I purchased an additional extender (AV600 Powerline WIFI extender) and attempted to pair it with the existing extender.  When I do this the Powerline led turns red on the existing extender and the adapter.  If I remove the new extender from the socket everything goes back to normal.  Can't figure out what I am doing wrong

  0      
 
  0      
 
#1
Options
1 Reply
Re:Network expansion not working
2019-08-01 16:31:41

@Richbat 

 

It is not that you are doing anything wrong. In fact, the powerline devices are pairing successfully or else no light would show up.

 

What is happening is that the speed is lowering with the introduction of the slower powerline device. You could try a different outlet, but if it continues to be red, it just means the speed is slow. Getting a powerline with AV1000 or higher should then give you the green LEDs that you are use to seeing (without the AV600 plugged in).

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1027

Replies: 1

Related Articles
Backyard Cottage Network Expansion
519 0
Further expansion needed....
554 0
[TP-PA8010P] Best option for network expansion?
460 0
Home expansion in regards to extenders or AP's
953 1
I’m not sure my WPA7510 extender is working
800 0
Device connection when home network is cloned
1581 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.