AV1000 Gigabit Power Sensative
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I can get my Power line set up and configured. putting router/bridge on secondary side (TP Link AC 1750). Can get it to work. Can't seem to get them working when plugged into the same plug. Also seem to be very power sensative to what else is plugged into the wall close by. Am I crazy or what are criteria for this, I am talking alarm clocks, and lamps, not appliances and the such. Thanks,
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Tell us about the setup. How do you have the adapters in the network.? Does it look like this?:
Modem - Router -Adapter A / Adapter B - client device
Next question. Are both adapters on a cirucit that resides in the same panel? PLC cannot work across panels.
Last question, for now. What lights are lit on each adapter?
- Copy Link
- Report Inappropriate Content
I am router/modem-Adapter A-Adapter B-AC1750 Router.
It is working between two different panels in house, but the one may be a slave of the other.
Right now it is green-red-green from top to bottom.
Jim
- Copy Link
- Report Inappropriate Content
If you have it working betweeen panels, regardless if one panel is a slave or sub panel or not that is impressive. These adapters are based on HomePlug AV2 standards and are not suppose to work between panels. Different breakers in a panel sure but not accorss panels. You would likely want to start there bring adapter b and the AC1750 into the same panel and see if the issue corrects itself.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 953
Replies: 4
Voters 0
No one has voted for it yet.