Difference between Reboot from router web GUI and manually switch on and off.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Difference between Reboot from router web GUI and manually switch on and off.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Difference between Reboot from router web GUI and manually switch on and off.
Difference between Reboot from router web GUI and manually switch on and off.
2020-11-15 14:00:50 - last edited 2020-11-16 15:48:40
Model: Archer C20  
Hardware Version: V5
Firmware Version: 200915

when every time I reboot my archer c20 router from its web based GUI / configuration page it always select channel 2 in 2.4ghz mode and I never looked at its 5ghz band to see if its also select some same 5ghz channel alltime. But when I manually reboot my router from my router power outlet it always select different channels in 2.4ghz mode. so whats the difference between reboot from web GUI and manually reboot.

 

Generally I live in a too much 2.4ghz band conjested environment. always 14 to 15  2.4ghz router signals are shown in my pcs wifi section. so I have to always manually reboot my router to avoid channel overlap. I think its a firmware issue. Why is it happening ? If it was firmware based issue then I wish TPLink authority will disclose a firmware update as soon as possible.

  0      
  0      
#1
Options

Information

Helpful: 0

Views: 681

Replies: 0

Related Articles