AX6000 firmware update broke Link Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX6000 firmware update broke Link Aggregation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX6000 firmware update broke Link Aggregation
AX6000 firmware update broke Link Aggregation
2021-03-01 22:16:28 - last edited 2021-11-23 02:42:14
Model: Archer AX6000  
Hardware Version: V1
Firmware Version: 1.2.1 Build 20210205 rel.12759

I just recently updated my AX6000 for the OneMesh capabilities, however after the update my NAS device that I had connected to the Link Aggregation ports no longer seems to be responding.  I have tried disabling the Link Aggregation, and then re-enabling to no avail.

 

I am going to attempt to reset the networking on the NAS to single port, but wanted to see if anyone else has seen this issue with this device and firmware update.

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:AX6000 firmware update broke Link Aggregation-Solution
2021-03-02 13:32:12 - last edited 2021-11-23 02:42:14
So I disabled and re-enable LAG again and this time it worked. So looks like if you lose access to your LAG devices just disable reboot and enable and reboot a few times and it goes good.
Recommended Solution
  2  
  2  
#2
Options
1 Reply
Re:AX6000 firmware update broke Link Aggregation-Solution
2021-03-02 13:32:12 - last edited 2021-11-23 02:42:14
So I disabled and re-enable LAG again and this time it worked. So looks like if you lose access to your LAG devices just disable reboot and enable and reboot a few times and it goes good.
Recommended Solution
  2  
  2  
#2
Options

Information

Helpful: 0

Views: 914

Replies: 1

Related Articles