C9 v1 in bridge mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello:
I need help getting my C9 to act as a wireless bridge/extender/AP. Here is my setup:
1. Updated to the latest firmware on the c9.
2. I have Xfinity INternet Service with a Gateway supplied by Comcast.
3. The Xfinity gateway LAN DHCP assigns 10.0.0.x addresses.
4. I gave the archer the WAN address that the gateway uses.
5. I set the internal IP on the Archer to 10.0.0.68
6. I went to Advance>System Tools>System Parameters and surveyed the 5G network the Xfinity gateway is broadcasting being sure to add the password for the gateway's wifi network.
7. I disabled DHCP.
8. At this point, I can longer get to the Archer's admin page at the new 10.0.0.68 address when connected to the xfinitiy router or the old 192 management IP when attached to the Archer's network.
Any help? Would blanking the WAN address and setting the Archer's gateway to the Xfinity gateway help?
