Some clients not showing on "Wired Clients"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Some clients not showing on "Wired Clients"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Some clients not showing on "Wired Clients"
Some clients not showing on "Wired Clients"
2022-07-07 16:51:45
Model: Archer AX6000  
Hardware Version: V1
Firmware Version: 1.2.4

I have a TL-SG1016DE plugged into a port on the AX6000. The router is configured to IP address 192.168.1.1, the TL-SG1016DE is 192.1.1.3 - yet the client list displayed on the AX6000 never shows this device. I can log into the switch to administer the settings normally. Do I need to configure the router or the switch to properly show this device?

  1      
  1      
#1
Options
3 Reply
Re:Some clients not showing on "Wired Clients"
2022-07-08 00:40:23

  @BassDaze 

 

Try the following:

Reserve an IP address in your AX6000 for the TL-SG1016DE - 192.168.1.3 (Network=>DHCP Server=> Address reservation).

Set your TL-SG1016DE IP address like this:

 

d588d76d2e204dcda6aa9b4608e0421c

Then TL-SG1016DE will receive its reserved IP address '192.168.1.3' from the AX6000, then check the AX6000 client list to see if TL-SG1016DE is present.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#2
Options
Re:Some clients not showing on "Wired Clients"
2022-07-08 16:27:39

  @terziyski well - this works for making the TL-SG1016DE appear in the DHCP Client list on the Network->DHCP Server page... but it does not show up on the Wired Clients list on the Advanced or Basic view. Also the name is blank.

  0  
  0  
#3
Options
Re:Some clients not showing on "Wired Clients"
2022-07-08 19:10:02

  @BassDaze 

 

Perhaps I've misinterpreted your description - I was thinking you were talking about DHCP Client list.

If it's about Network Map => Wired devices I don't believe the switch will be counted as a client there.

I have several easy smart switches (different models) in my network and non of them is registered in the Network Map => Wired Clients on the router.

There's no specific configuration for this (on the switch itself) to be changed.

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#4
Options