Bridge Mode for Archer C5400
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Bridge Mode for Archer C5400
Model :
Hardware Version :
Firmware Version :
ISP :
Region - USA
Model - Archer C5400 V2
Firmware - Most current as of Jan 16, 2017
Can anyone please tell me how to set IPV4 to bridge (pass through) mode? I see the option on IPV6, but not on IPV4. I must use my cable modem as the router and DHCP so need C5400 in bridge mode because I have devices connected to the cable modem gigabit ports that need to communicate the wireless devices connected to the C5400 (e.g. avoid double NAT).
Thanks
Hardware Version :
Firmware Version :
ISP :
Region - USA
Model - Archer C5400 V2
Firmware - Most current as of Jan 16, 2017
Can anyone please tell me how to set IPV4 to bridge (pass through) mode? I see the option on IPV6, but not on IPV4. I must use my cable modem as the router and DHCP so need C5400 in bridge mode because I have devices connected to the cable modem gigabit ports that need to communicate the wireless devices connected to the C5400 (e.g. avoid double NAT).
Thanks