@Born2Code Well not sure I can help here but it's not going to let you (probably not) create a wifi network as one it currently sees so what I would do is take down the orbi network completely before...

@BILL1840 Do you have a static IP configured on the NVR itself? Check that and also I put my NVR on the deco Eth port rather than through one of my switches as one of the steps I was taking to...

@Ayengar You can set device band preference - to into your Deco app and where it says "xx online clients" click the link to pull connected list. You can select them then go to 'connection preference'...

@ayengar While in most cases this goes without saying - make sure your firmware on all involved devices are up to date. Also in my case, I cannot have a single network with all three wifi bands, 6ghz...

@Ayengar that works too lol. I borrowed a 50ft from my work to do the same once xD

@Ayengar Don't know if this is any help but I will say I struggled with some issues with stability with my moderately complex setup due to I believe switch placement in one area. I think it has to do...