Forums/
Deco
2 weeks ago
@BritG1 You said " understand I should not put a 2.5GB Switch in front of the router, but how can I cheaply share the 2.5GB service?" I hate to be flippant, but you would put it *after* the router in...
0HELPFULS
Forums/
Deco
3 weeks ago
In the past, using an ethernet switch for the backhaul, I found only TP-Link switches are capable of supporting some specific protocol the DECO uses to keep in sync. Since the BE11000 supports 2.5...
0HELPFULS
Forums/
Deco
2026-01-13 22:45:18
@T_R_K There were two main issues that were driving the network stability and I had to sort them one by one (and keep in mind this is a flat network with unmanaged switches) 1) Most obvious one was I...
0HELPFULS
Forums/
Deco
2026-01-12 15:26:18
@T_R_K I have a question. About options in the app. I use my Deco 6e as an access point (essentially letting the ISP's router hand out IP addresses, not the Deco). But yet even when I do that, the...
0HELPFULS
Forums/
Deco
2026-01-12 13:30:35
@jzchen To answer your question, yes, I found the issue (I'm using unmanaged switches). I had two connecting wires between two switches, and the network settled down yesterday morning, so I had a...
1HELPFULS
Forums/
Deco
2026-01-09 22:03:59
I shut down all the Deco nodes which clears out the app and moved the main node to the wiring closet to test solo. It worked just fine, so I moved that node up to the main floor, and then started up...
0HELPFULS