Unable to use remote access when configured on network with client isolation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to use remote access when configured on network with client isolation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to use remote access when configured on network with client isolation
Unable to use remote access when configured on network with client isolation
2018-01-02 04:57:08
Model :

Hardware Version :

Firmware Version :

ISP :

I want to connect my TP-Link smart plugs HS-100, HS-105 on my wifi network with client isolation enabled. I understand that I need to disable client isolation in order to configure them; I've done so with no problem. However after I enable remote access and enable client isolation on my network, I can't access the TP-Link smart plugs from my Kasa App! Is this a known issue and is there a upcoming fix? The smart plugs shouldn't need any local access after their configured, and I am not sure why it needs it to work when remote access is enabled!
  0      
  0      
#1
Options
2 Reply
Re:Unable to use remote access when configured on network with client isolation
2018-01-08 19:00:05
If you enable client isolation you need to enable remote control option to control the smart plug
  0  
  0  
#2
Options
Re:Unable to use remote access when configured on network with client isolation
2018-01-09 09:17:54
That did not work for me. I made sure remote was enabled, but the moment I turn on client isolation, the app can't see the device anymore.
  0  
  0  
#3
Options