LED Lightstrip Cable In-Wall
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Does anyone know if the wire on the KL430 from the controller to the light strip is rated for in-wall installation? I can't seem to find anything on it, which leads me to believe it's probably not.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Because it is low voltage, it should be OK as long as you do not put it in the same box with house wiring.
- Copy Link
- Report Inappropriate Content
@B.Will I know, I'm pretty sure that it should be ok, but I could be selling my house in a few years. I just want to make sure that it would pass an inspection, and want to do it the right way before putting tile on the wall. I did just find AWG style 2464 25AWG 80C 300V VW-1 FT1 on the cable, but I don't know if that can be translated into class 2.
The other options I can think of would be cutting the cable and using cat5e or speaker wire I have laying around which are both rated for in-wall, but I'd really rather not cut any cables unless necessary. It's in a kitchen, the plug is in a cabinet under the countertop, and the lights are going on a floating shelf above the counter where installing an electrical outlet wasn't an option.
- Copy Link
- Report Inappropriate Content
I thought it might be ok as well, but I found these sections in the manual:
So if there are any regulations that need to be met I probably would not do it.
- Copy Link
- Report Inappropriate Content
@Tony I just found that too and came here to post it
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If after setting up the light strip the same section does not light up at all there may be an issue with it. I would reach out to our support team at that point.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1191
Replies: 6
Voters 0
No one has voted for it yet.