RV30 MAX Plus navigating route to desired location
Hey there ppl,
Little question that I seen not to find an answer for just yet.
Question is, is there a way to set the navigation for the RV30 to leave the base, and then travel a specific line to the desired section to clean?
Currently it'll leaves the dock then go diagonally and run into a table, but if it would just go straight off the dock to the end of room then it would have straight shot
Thanks in advance
Robot vacuum cleaning routes are not user‑configurable. In your case, could you check if there is enough clear space around the charging station? Also, how close is the table to the dock? If it’s placed too near, the robot may adjust its path to avoid the obstacle.
For this model, please ensure at least 0.5 m (1.6 ft) of clear space on each side of the charging dock, and 1.5 m (4.9 ft) of open area directly in front of it.
