How to wire with this config (2 gang)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to wire with this config (2 gang)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to wire with this config (2 gang)
How to wire with this config (2 gang)
2019-10-12 22:36:40
Model: HS220  
Hardware Version:
Firmware Version:

I have a 2 gang switch in my kitchen where one switch controls the countertop lights and the other controls the overhead lights.  I'm trying to install this to the overhead lights but the wiring configuration is different than any of the videos I've seen so far.  Anyone know how to connect the switch when the wires look like this:

 

  0      
  0      
#1
Options
3 Reply
Re:How to wire with this config (2 gang)
2019-10-13 14:14:31

@Zac 

 

Your existing kitchen lights switch should have two black wires attached.

Connect each of them to the HS220 side screws.

Connect the green the group of greens under the wirenut.

Connect the white to the group of whites under the wirenut.

Come back and let us know how it goes.

  0  
  0  
#2
Options
Re:How to wire with this config (2 gang)
2019-10-13 14:54:38

@B.Will Hi Bill, thanks for the reply.  To clarify a bit, here is the wiring I found originally and what I copied with the 220.  With this config the switch doesn't even power up.  I can play around and remove some of the neutrals and the switch will power up and let me set it up but won't control the lights.  What am I doing wrong?

 

  0  
  0  
#3
Options
Re:How to wire with this config (2 gang)
2019-10-13 15:19:40 - last edited 2019-10-13 20:28:41

@Zac 

That looks to be the correct wiring.

Try swapping the black leads.

You may need to get a professional

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1791

Replies: 3

Related Articles