Dimmer switch doesn't go to full brightness with long press turn on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Dimmer switch doesn't go to full brightness with long press turn on

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dimmer switch doesn't go to full brightness with long press turn on
Dimmer switch doesn't go to full brightness with long press turn on
2020-12-06 17:50:41
Model: HS220  
Hardware Version: V2
Firmware Version: 1.0.4

I just installed the dimmer switch in my bedroom. It appears to be working properly however in the tutorial it states that if you hold the switch for two seconds when powering on the light it will turn it on at Max brightness as opposed to the brightness setting the light was on when turned off. I can't seem to get this to work as anybody else had this problem? Is there anything I can do to fix it?

  0      
  0      
#1
Options
1 Reply
Re:Dimmer switch doesn't go to full brightness with long press turn on
2020-12-08 17:55:50

@Canabuc 

 

Try going through the dimming calibration, then set the long press for instant on: https://www.tp-link.com/support/faq/2938/

  0  
  0  
#2
Options