Accepted Make ACL in Omada time dependand
Accepted Make ACL in Omada time dependand
Hi
Is there any possibility to make access control lists (ACL) in Omada (OC200, TL-R605 gateway) dependent on time range? Is there any feature? I'm missing something? As I remember when I was using older routers without Omada controller "in charge of everything", there was a possibility to block access of specific predefined ip_ranges in specific time_ranges.
Is there any feature in Omada controller?
If not will You add one?
Best reards
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi All,
It's confirmed that the time-based ACL in Omada is planned to be added in the firmware adapted to Omada Controller v5.6, which can be expected to release at the end of September. So stay tuned!
Note: the release time mentioned here is for your reference only, it's subject to the actual firmware condition.
Updated on October 24, 2022:
Sorry that the Router firmware adapted to Omada Controller v5.6 is not ready for release yet, the time-based ACL will be available soon once the firmware is approved to be released. Please wait patiently.
- Copy Link
- Report Inappropriate Content
I can't find ACL effective time range either, maybe we should feed back this requirement to TP-Link and ask them to add it.
- Copy Link
- Report Inappropriate Content
Dear @dartom,
dartom wrote
Is there any possibility to make access control lists (ACL) in Omada (OC200, TL-R605 gateway) dependent on time range?
Sorry that it doesn't support such feature in Controller mode at present.
I've forwarded your feedback as a feature request to the product team for further evaluation, and it will be supported in the near future.
- Copy Link
- Report Inappropriate Content
@Fae any update on this? Just went all in on tp-link and have 2 x EAP660's and a ER605, to find that I can't apply a time based acl in the Controller although it can be done if not managed by the Controller.
- Copy Link
- Report Inappropriate Content
@Fae any updates on this topic? As far as I looked up there is still no such feature on Omada 5.0
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Fae What the tentative release date of 5.2 as of now?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Just installed the version 5.4.6 (linux), but this version still does not contain the time schedule based ACL support.
Can You please update us, when it is expected to be implemented in Omada Software Controller?
Thanks
gZoma
- Copy Link
- Report Inappropriate Content
Hi All,
It's confirmed that the time-based ACL in Omada is planned to be added in the firmware adapted to Omada Controller v5.6, which can be expected to release at the end of September. So stay tuned!
Note: the release time mentioned here is for your reference only, it's subject to the actual firmware condition.
Updated on October 24, 2022:
Sorry that the Router firmware adapted to Omada Controller v5.6 is not ready for release yet, the time-based ACL will be available soon once the firmware is approved to be released. Please wait patiently.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 3
Views: 1208
Replies: 18
Voters 3
