@TP-Link hello, I've just purchased TP-Link Deco M4R, 2-pack.

Sucesfully installed 1st Deco (main), but the second is looping on solid-yellow. 

Already tried:

1) reset - no change

2) connect to PC with static 192.168.0.2, unable to PING 192.168.0.1, unable to open page http://192.168.0.1 - unable to do firmware recovery

Model: Deco M4R(EU), V. 2.0,

please advice.

  @Kuba78 

I would suggest go to support link 

https://www.tp-link.com/us/support/contact-technical-support/

and try to do live chat support or email. Explain everything you did.

They may ask you to try a few things or will send you warranty replacement and it asked you to register your unit if you haven't already 

  @TP-Link Hello, I just got a Deco BE11000 and one of the nodes is stuck in yellow. Apparently the firmware version is 1.1.7 Build 20250324 Release. 32980. Please Help!

  @v3maldo 

I would suggest going to

https://www.tp-link.com/us/support/contact-technical-support/

Asking for help on this forum is almost pointless. They don't monitor this as much.

  @TP-Link 

1. The model number as well as the firmware version of the Deco;

deco x55

firmware 1.4.6

2. Which problem description is more like your current issue?

the main deco is set up and doesn't seem to have problems, the lights on the main one currently is solid green. The second deco is the one I'm having a problem with it's being stuck on the blinking yellow loop. And whenever I unplugged the power  and reset it using the button on the bottom it is continuing to have the same problem  

3. Have you tried the hardware reset and firmware recovery suggestions? what are the results?

I have not  and I'm not completely sure how to do it and didn't wanna chance messing it up more