Business Community > Gateways > ACL for Wiregaurd
< Gateways

ACL for Wiregaurd

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ACL for Wiregaurd

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ACL for Wiregaurd
ACL for Wiregaurd
2024-10-19 16:01:27 - last edited 2024-10-21 01:06:46
Tags: #VPN #ACL #WireGuard
Model: ER605 (TL-R605)  
Hardware Version: V2
Firmware Version: 2.2.6

Hello, was looking to use the wiregaurd vpn on ER605. while configuration works following https://community.tp-link.com/en/home/forum/topic/619652 i'm not able to apply ACLs to limit access to certain subnets. Could not find any documentation on how to configure wiregaurd ACL, any advice please? 

 

  1      
 
  1      
 
#1
Options
1 Reply
Re:ACL for Wiregaurd
2024-10-21 01:06:34

Hi @SivaM 

Thanks for posting in our business forum.

Here are some you could try:

1. Refer to the ACL guide we have on the forum. There was a case where ACL applied for the WG scenario.

2. At least a diagram should be posted to show how you would like to the ACL networks.

3. WG access is controlled by its routing table. And you should pay attention to how you configure the Allowed IPs as I have specifically explained this part. Instead of using the ACL, you should examine how you set that part up.

  1  
  1  
#2
Options

Information

Helpful: 1

Views: 463

Replies: 1

Tags

VPN ACL WireGuard
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.