Business Community > Gateways > Has anyone successfully gotten through on port 8080?
< Gateways

Has anyone successfully gotten through on port 8080?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Has anyone successfully gotten through on port 8080?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Has anyone successfully gotten through on port 8080?
Has anyone successfully gotten through on port 8080?
2024-11-21 16:07:40 - last edited 2024-11-21 17:01:43
Tags: #Routing #Network Connectivity #Controller #Firewall
Model: ER7206 (TL-ER7206)  
Hardware Version: V2
Firmware Version: 2.1.2 Build 20240324 Rel.46738

I am trying to connect remotely to the camera built into the Flashforge printer I have which is on port 8080 (192.168.10.110:8080/?action=stream). I can connect locally, but cannot connect remotely. I have set up a vserver rule for it an set up port forwarding. I have a static IP and can see the port is open when checking externally. I am thoroughly confused as to why this is. Any help will be greatly appreciated.

 

 

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Has anyone successfully gotten through on port 8080?-Solution
2024-11-21 16:44:44 - last edited 2024-11-21 17:01:43

  @3DScanSTL 

 

remove port trigger config, you only need virtual server

 

Recommended Solution
  0  
  0  
#4
Options
5 Reply
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 16:19:59

  @3DScanSTL 

 

hard to say since you haven't shown any screenshots of your configuration.

 

 

  0  
  0  
#2
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 16:26:19

  @MR.S 

 

I assumed that the image showing port 8080 open from the outside was sufficient to show that the port is open. I can access my NAS just fine. 

 

  0  
  0  
#3
Options
Re:Has anyone successfully gotten through on port 8080?-Solution
2024-11-21 16:44:44 - last edited 2024-11-21 17:01:43

  @3DScanSTL 

 

remove port trigger config, you only need virtual server

 

Recommended Solution
  0  
  0  
#4
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 17:00:44

  @MR.S 

So this is bizarre, I pulled up the link and it first said it wasn’t available, but I set my phone down and after about 15-20 seconds it connected. The throughput is terrible, but I did connect. I had not waited this long previously as I was used to connecting immediately.

  0  
  0  
#5
Options
Re:Has anyone successfully gotten through on port 8080?
2024-11-21 17:09:09

  @3DScanSTL 

 

i use controller so i don't know how it is in stand alone that you use, but all port forwards go lightning fast.. there is no delay at all.

 

 

  0  
  0  
#6
Options

Information

Helpful: 0

Views: 784

Replies: 5

Tags

Routing Network Connectivity Controller Firewall
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.