Problem with the channel width in the EasyMesh network on Archer AX80 and two satellites Archer AX73
Problem with the channel width in the EasyMesh network on Archer AX80 and two satellites Archer AX73
I have the same problem as some users describe for Archer AX80 and Archer AX73 Routers when they connect to EasyMesh!
As the main Router I use Archer AX80 V1.0 (latest firmware Archer AX80(EU)_V1_1.1.4 Build 20241227) and as satellites I have two Archer AX73 V2.0 (also latest firmware Archer AX73(EU)_V2_1.1.2 Build 20250210) and everything is connected with Ethernet Backhaul via LAN cables CAT 5E.
On Archer AX80 in Wi-Fi settings I only have 5GHz enabled, while 2.4GHz is disabled and I don't use it.
The problem is the same as described by some users, when I select the channel width of 20/40/80 MHz on the main router, it is only on that main router Archer AX80, while on the other two Archer AX73 satellites it is always 20/40/80/160MHz and this cannot be changed in any way...
Also, another problem is that in the Tether application for Archer AX80 I do not see the option for EasyMesh, only OneMesh, and that is very irritating?
The third problem is that when I successfully add the Archer AX73 satellites to EasyMesh via the LAN1 port and then want to connect them via the WAN port, then the devices will not connect via the Ethernet Backhaul, but only wirelessly...
Do you have a solution for all this?
Regards!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @zexoni70,
We are delighted to announce the release of the ArcherAX80_V1 pre-release firmware! This update has additional changes.
Pre-release Firmware for Archer AX80 Supports EasyMesh in AP Mode, DoH/DoT, ECO Mode, and More
We encourage you to try this firmware and take advantage of the new features.
Thank you for your feedback and suggestions.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 607
Replies: 11
Voters 0
No one has voted for it yet.