Tapo p110 no longer connecting to home assistant after firmware update
I have about 20 Tapo plugs (p100, p110, p105). All were connected to Home Assistant. In the past few days 4 of the p110 will no longer connect to HA giving a failed setup message. Only p110 with the firmware number above are affected. All the p110 using older firmware are fine.
Any cure or way to roll back the firmware?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Sending this your way as I am unaware of any way to roll back the firmware? I know you can on the routers but not sure about any of tp-link smart products?
Would resetting them all roll back the firmware to factory?
- Copy Link
- Report Inappropriate Content
Geoff123322 wrote
I have about 20 Tapo plugs (p100, p110, p105). All were connected to Home Assistant. In the past few days 4 of the p110 will no longer connect to HA giving a failed setup message. Only p110 with the firmware number above are affected. All the p110 using older firmware are fine.
Any cure or way to roll back the firmware?
Tapo device does not support firmware downgrade. Regarding your situation, please note that Home Assistant is not an officially supported third‑party platform for Tapo products. As such, we are unable to provide technical support for setups involving unofficial integrations or unsupported usage methods.
- Copy Link
- Report Inappropriate Content
@Wayne-TP Do you honestly feel that this is a valid response.
They used to work and you (TAPO) have just pushed an update to stop them working, this is unacceptable.
- Copy Link
- Report Inappropriate Content
According to a thread elsewhere, turning off 3rd party apps and then turning it back on should fix the issue.
https://github.com/home-assistant/core/issues/154582
I tried it on mine and it seems to have worked.
But when adding a new plug, I had to do it via the IP address on the page
TP-Link Smart Home ---> Add device
as it didn't show up as auto detected.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 124
Replies: 4
Voters 0
No one has voted for it yet.