Fire cube cannot connect to BE900 6GHZ after firmware update

Nitrostar

Yesterday - last edited 18 hours ago

Posts: 9

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2024-06-18

Fire cube cannot connect to BE900 6GHZ after firmware update

Yesterday - last edited 18 hours ago

Tags: #Network Connectivity #Firmware Update #6 GHz

Model: Archer BE900

Hardware Version: V2

Firmware Version: 1.2.1 Build 20250917 rel 48782 5553

I had no problems with my BE900 until I updated the firmware to 1.2.1. Now my firecube will not connect to the 6ghz band. It can see the band but says it is out of range. The firecube is 5 meters from the router in the same room.

My laptop connects ok to the BE900 via wifi 6E.

The 5Ghz and 2.4Ghz work ok.

I have already rebooted the router multiple times and also un-plugged the router to hard reset it but the problem persists.

1 Accepted Solution

Joseph-TP

Yesterday - last edited 23 hours ago

Posts: 5680

Helpful: 385

Solutions: 2138

Stories: 0

Registered: 2024-06-22

Re:Fire cube cannot connect to BE900 6GHZ after firmware update-Solution

Yesterday - last edited 23 hours ago

Hello @Nitrostar ,

I have followed up on your case here. Please pay attention to it.

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.

Fire cube cannot connect to BE900 6GHZ after firmware update

Fire cube cannot connect to BE900 6GHZ after firmware update

Information

Voters 0

Tags